The use of a solar panel that is placed with the static position in the solar power plant make energy conversion is done less than optimal. This is because the solar panels are not always perpendicular to the Sun. This study discusses the system that can control solar panels so solar panel will always be facing towards the oncoming sunlight and electricity output gain systems are optimal. Control system of solar panels can move towards the y axis (North-South) and x axis (East-West). The movement of the solar panels towards the y axis moves with time-based, while the movement of the solar panels towards the x axis has two mode switches automatically depending the intensity of the Sun. two mode it is the mode of movement of solar panels based on LDR (Light Dependent Resistor) sensor and the mode of movement of the solar panels based on RTC (Real Time Clock) module. X axis movement mode selection obtained from the results of the calculation perceptron algorithms with parameter is the LDR sensor and rain sensors and found the results of the validation tests in the form of 100% accuracy rating. Then do also the measurement of power generated through the observation field for two days with the results of the efficiency of absorption of energy by solar panels with a control system is 59.5% whereas solar panels without a control system is 49.6% from the total maximum power produced by the solar panels 10 Wp.

Penggunaan panel surya yang diletakkan dengan posisi statis pada Pembangkit Listrik Tenaga Surya (PLTS) membuat konversi energi yang dilakukan kurang optimal. Hal ini dikarenakan panel surya tidak selalu tegak lurus terhadap matahari. Penelitian ini membahas tentang sistem kendali panel Surya sehingga panel surya akan selalu menghadap ke arah datangnya sinar matahari dan sistem mendapatkan keluaran listrik yang optimal. Sistem kendali panel surya dapat bergerak terhadap sumbu y (utara-selatan) dan sumbu x (timurbarat). Pergerakan panel surya terhadap sumbu y bergerak dengan berdasarkan waktu, sedangkan pergerakan panel surya terhadap sumbu x memiliki dua mode yang switch otomatis bergantung intensitas matahari. dua mode itu adalah mode pergerakan panel surya berdasarkan sensor LDR(Light Dependent Resistor) dan mode pergerakan panel surya berdasarkan modul RTC(Real Time Clock). Pemilihan mode pergerakan sumbu x didapat dari hasil perhitungan algoritma perceptron dengan parameter sensor LDR dan sensor Hujan dan didapati hasil pengujian validasi berupa nilai akurasi sebesar 100%. Kemudian dilakukan juga pengukuran daya yang dihasilkan melalui observasi dilapangan selama dua hari dengan hasil efisiensi penyerapan energi oleh panel surya dengan sistem kendali sebesar 59,5% sedangkan panel surya tanpa sistem kendali sebesar 49,6% dari total maksimum daya yang mampu dihasilkan oleh panel surya 10 Wp